из мануала по родиусу (на английском)
если сам не силен то переводчики онлайн в помощь (правда корявые они совсем)
1170 - Refer to P0372
0372 - Crank Angle Sensor Malfunction
- Even though cam position recognition
is normal, no crank angle signal recognition
(missing tooth).
- Check the sensor wiring harness for
ECU pin #90 and #82 (open, short, poor
contact).
- Check the resistance of crank angle
sensor: 1090 Ω ± 15 %.
- Measure the air gap: 0.3 ~ 1.3 mm
• 1.3 mm of air gap: outputs 1.0 V at
40 rpm
• 0.3 mm of air gap: outputs 150 V at
7000 rpm
- Check the teeth condition.
• Drive plate (A/T), DMF (M/T)
- Replace the ECU if required.